Crate geop_ops_plastic 

Features for designing moulded and printed housings: a rib grown from an open profile up to the walls around it, a lip and the groove that takes it where two halves of an enclosure meet, and a draft on the faces a mould slides along.

Re-exports

pub use operation::Draft;

pub use operation::DraftArgs;

pub use operation::Groove;

pub use operation::GrooveArgs;

pub use operation::Lip;

pub use operation::LipArgs;

pub use operation::Rib;

pub use operation::RibArgs;

pub use operation::RibDirection;

pub use operation::RibSide;

Modules

band

Chains of curves in a plane, offset sideways — and the band between two offsets of one chain, the profile a rib or a lip is swept from.

draft

draft: planar faces of a solid tilted about a neutral plane, so the part comes out of its mould.

lip

lip and groove: the joint between the two halves of an enclosure — a raised strip along one half’s rim, and the recess in the other’s that takes it.

operation

The plastic features as operations of a program: Rib, Lip, Groove and Draft.

rib

rib: a thin wall grown from an open sketch profile until it meets a solid, and joined to it.

Functions

register

Adds what this crate offers an editor to r: the features of plastic parts: ribs, drafts, lips and grooves.